The purpose of this project is to design and build a pair of machines that will dispense polyurethane into filter end caps.

Dynamic Design Solutions, Inc. has experience designing equipment to automatically load a punch press. This station loads metal blanks into a forming press and then removes the completed part from the press.

The station included all of the mechanical design, electrical and controls design and both the cell and press safety interfaces.

The purpose of this project is to design and build a machine that will drill holes into the bottom of an aluminum valve stem body.

Dynamic Design Solutions, Inc. can design and build leak test equipment for a variety of applications.  We have built stations that test the integrity of various injection molded parts.

Dynamic Design Solutions, Inc. can design and build inspection test equipment for a variety of applications. We have built stations that measure diameter, length and run out on round parts to 3 Microns resolution.

The purpose of this project was to integrate a vision system to inspect a gear assembly for proper orientation of the driven gears relative to the main drive gear.

Dynamic Design Solutions is a Certified Vision Integrator for both Cognex™ and DVT™ vision sensors. We were contracted by a battery manufacturer to inspect their various battery types for defects on both the positive and negative ends.

Our system inspected over 600 batteries per minute and looked for almost 10 different defects per end including, scratches, dents, dirt, and other length defects. We also looked at the registration of the label and rejected any battery that didn’t meet the quality standard.

The purpose of this project is verify that the paper rolls have the proper spacing prior to flipping them into position.  This will prevent injury and allow proper operation of the downstream equipment.

Dynamic Design Solutions has created a thread pitch measurement station that can be used to measure internal or external threads.